al
table_vac_threshold
tvt
Trendsetter_VLFTrendsetter_VLF_Auto
Sets the minimum allowable vacuum pressure level for the firmware to believe
that a plate is being held by the table vacuum. When the measured vacuum
pressure is below this parameter, the firmware will not believe that a plate is
on the load/unload table. The vacuum is only checked at the beginning of the
load cycle, before the table is lifted up.
word
200
0 to 1024 (no units)
Typically there should be no need to adjust this parameter, as there is
plenty of difference in the vacuum level between when there is and isn't a
plate covering the vacuum holes.
cal
command: table vac